Trang chủ » Bo mạch I/O kết nối máy tính (PC Boards) » Bo mạch PCI 1 cổng DeviceNet Master thông minh ICP DAS PISO-DNM100U-D CR

Bo mạch PCI 1 cổng DeviceNet Master thông minh ICP DAS PISO-DNM100U-D CR

1 Port Intelligent DeviceNet Master Universal PCI Board

Chia sẻ:
Model: PISO-DNM100U-D CR
Views: 528

Bo mạch PCI 1 cổng DeviceNet Master thông minh ICP DAS PISO-DNM100U-D CR

PISO-DNM100U can represent an economic solution of DeviceNet application and be a DeviceNet master device on the DeviceNet network. It is a “Predefined Master-Slave connection Set”. PISO-DNM100 supports Group 2 only Server and UCMM functions to communication with slave devices. It has an independent CAN bus communication port and has the ability to cover a wide range of DeviceNet applications.

Besides, PISO-DNM100U uses the CAN controller Phillips SJA1000T and transceiver 82C250, which provide bus arbitration, error detection with auto correction and re-transmission function.It can be installed on almost any windows-based system, for example Windows system. It is popularly applied in the industrial automation, building automation, vehicle, marine, and embedded control network. In order to expand the DeviceNet functions of ICPDAS products, PISO-DNM100U is developed for this purpose.

Software
Driver Windows XP/7/8/10 (32-bit/64-bit OS)
Library VB 6.0, VC++ 6.0, BCB 6.0, Visual Studio .NET
LED Indicators
Status Green LED, Red LED
PC Bus
Type Universal PCI supports both 5 V and 3.3 V PCI bus
Board No. By DIP switch
DeviceNet
Controller NXP SJA1000T with 16 MHz clock
Microprocessor inside with 80186 80MHz
Transceiver NXP 82C250
Ports 1
Baud Rate 125 k, 250 k, 500 k
Isolation 3000 VDC for DC-to-DC, 2500 Vrms for photo-couple
Terminal Resistor Jumper for 120 Ω terminal resistor
Porotocol DeviceNet Volumn I ver2.0, Volumn II ver2.0
CAN Specification ISO-11898-2, CAN 2.0A and CAN 2.0B
Power
Consumption 300 mA @ 5 V
Mechanical
Dimensions (mm) 138 x 22 x 105 (W x L x H)
Environmental
Operating Temperature 0 ~ +60 ℃
Storage Temperature -20 ~ +70 ℃
Humidity 5 ~ 85% RH, Non-condensing

There exist two memory areas, “Input Area” and “Output Area”. The input data of all DeviceNet slaves would be stored in the “Input Area” by DeviceNet master scan engine. Oppositely, the output data of those DeviceNet slaves would be in the “Output Area”. Please refer to the following figure.

Users can read a bulk data from “Input Area” in the DeviceNet Master module, like PISO-DNM100U or I-8124W. This bulk data contains multiple devices’ input statuses. If one of the input status of the remote DeviceNet slave changes, the corresponding data located in the “Input Area” would change immediately. Oppositely, the “Output Area” contains multiple devices’ output data. Users may change the output value of a certain device by changing the corresponding data located in the “Output Area”.

PISO-DNM100U-D     CR 1 Port Intelligent DeviceNet Master Universal PCI Board (9-pin D-Sub Connector) (RoHS)

 

TOP HOME