Trang chủ » Industrial Communication » Ethernet Communication » Ethernet Switch » Switch công nghiệp quản lý Layer-2 6 cổng Ethernet+2 cổng quang (Multi-mode, ST) ICP DAS MSM-508FT-T CR

Switch công nghiệp quản lý Layer-2 6 cổng Ethernet+2 cổng quang (Multi-mode, ST) ICP DAS MSM-508FT-T CR

8-port Industrial Ethernet Layer 2 Managed Switch with 2-Fiber Port (Multi-mode, ST Connector)

Chia sẻ:
Model: MSM-508FT-T CR
Views: 552

Switch công nghiệp quản lý Layer-2 6 cổng Ethernet+2 cổng quang (Multi-mode, ST) ICP DAS MSM-508FT-T CR

The MSM-508FT-T is an 8-port Industrial Ethernet Layer 2 Managed Switch with 2-Fiber Port that secures data transmission by using fiber optic transmission to provide immunity from EMI/RFI interference. It is perfect solution for applications where transmission must be protected from electrical exposure, surges, lightning or chemical corrosion.

It can be managed through RS-232 port via serial console or Ethernet port using telnet or Web browser. In addition, the switch supports a lot of powerful managed functions, such as 802.1Q Tag-based VLAN, Portbased VLAN, 802.1p QoS (Quality of Service), Port Trunking, Spanning Tree, Cable Testing and Port Mirroring.

Built-in ICP DAS Cyber-Ring technique that enable multiple switches to be placed into a redundant ring. Typically it detects and recovers from a fiber or copper link failure within approximately 20 ms V for the majority of applications a seamless process. Modbus/TCP, Modbus/RTU and OPC supported, SCADA application can monitor status of Ethernet and fiber port with Modbus or OPC protocol.

MSM-508F provides two power inputs that can be connected simultaneously to live DC power sources. If one of the power inputs fails, the other live source acts as a backup to automatically support the it’s power needs. And the relay output facility can deliver warning signal while power or network link failure.

Models MSM-508FC-T
MSM-508FCS-T Series
MSM-508FT-T Series
Technology
Standards IEEE 802.3, 802.3u and 802.3x
Processing Type Store & forward, wire speed switching
MAC Addresses 2048
Memory Bandwidth 3.2 Gbps
Frame Buffer Memory 1 Mbit
Flow Control IEEE 802.3x flow control, back pressure flow control
Protocol VLAN, QoS, Port Trunk, SMTP, TELNET
Ethernet Interface
RJ-45 Ports 10/100 Base-TX auto negotiation speed, F/H duplex mode, and auto MDI/MDI-X connection
Fiber Optics Port 2-port 100 Base-FX
LED Indicators 10/100M, Link/Act, Full duplex/Half duplex (Fiber Port)
Ethernet Isolation 1500 Vrms 1 minute
Multi-mode Multi-mode Fiber Cables 50/125, 62.5/125 or 100/140 μm
Distance 2 km, (62.5/125 μm recommended) for full duplex
Wavelength 1300 or 1310 nm
Min. TX Output -20 dBm
Max. TX Output -14 dBm
RX Sensitivity -34 ~ -31 dBm
Single-mode Single-mode Fiber Cables 8.3/125, 8.7/125, 9/125 or 10/125 μm
Distance 30 km, (9/125 μm recommended) for full duplex
Wavelength 1300 or 1310 nm
Min. TX Output -15 dBm
Max. TX Output -8 dBm
RX Sensitivity -36 ~ -31 dBm
COM1 RS-232 (TxD, RxD and GND); Non-isolated
COM2 RS-485 (D2+, D2-; self-tuner ASIC inside); Non-isolated
Frame Ground for EMS Protection Yes
Digital Input/Output
Digital Input 3-channel, Wet Contact, L: +11 VDC Max., H: +19 VDC ~ +30 VDC
Digital Output 3-channel, Open Collector, Sink/NPN, 30V/100 mA Max.
Power
Input Voltage Range +12 VDC ~ +48 VDC Redundant Dual Inputs (Non-isolated)
Power Consumption 0.3 A @ 24 VDC
LED Indicator Yes
Protection Power reverse polarity protection
Frame Ground for EMS Protection Yes
Connector 20-Pin Removable Terminal Block
Mechanical
Casing Metal
Environmental Rating IP30 Protection
Dimensions (W x L x H) 47 mm x 140 mm x 175 mm 47 mm x 142 mm x 175 mm
Installation DIN-Rail Mounting or Wall mounting
Environment
Operating Temperature -30 °C ~ +75 °C
Storage Temperature -40 °C ~ +85 °C
Ambient Relative Humidity 10 ~ 90% RH, non-condensing
Accessories
Include Cable CA-090510 x 1
MSM-508FT-T     CR 8-port Layer 2 Managed Switch with 2-Fiber Port, Multi-mode, ST Connector (RoHS)
CA-090510 9-Pin Female D-Sub & RJ-45 Cable, 1 M Cable
MDR-20-24 24 V/1 A, 24 W Power Supply with DIN-Rail Mounting
MDR-60-24 24V/2.5A, 60 W Power Supply with DIN-Rail Mounting
DIN-KA52F 24 V/1.04 A, 25 W Power Supply
DR-120-24 24 V/5 A, 120 W Power Supply with DIN-Rail Mounting
TOP HOME