Trang chủ » Industrial Communication » Bộ chuyển đổi RS-232/422/485 sang Hart ICP DAS I-7570 CR

Bộ chuyển đổi RS-232/422/485 sang Hart ICP DAS I-7570 CR

Serial to HART converter

Chia sẻ:
Model: I-7570 CR
Views: 1403

Bộ chuyển đổi RS-232/422/485 sang Hart ICP DAS I-7570 CR

I-7570 is a Serial to HART converter and can be used as a HART master with HC_Tool utility or a HART slave with HDS utility.

(1) I-7570 as HART Master :

It allows users to access the HART slave by using RS-232 / RS-422 / RS-485. These HART slave devices may be a transmitter, actuator, current output device and so forth. In addition, by using the I-7570 utility tool, users can configure module and test HART communication easily and quickly.

(2) I-7570 as HART Slave :

HART Device Simulator (called HDS) is the HART device simulation software developed by ICP DAS. It can be used to simulate multi HART slave devices simultaneously to exchange data with HART master device by using ICP DAS HART converter (like: I-7567 / I-7570 / I-7547) connected to any COM port (USB / 232 / 485 / Ethernet). By this way, users can develop or verify the HART master program without any HART slave device.

  • Current Measuring
  • Petrochemical Industry Application
  • Environment Monitoring
  • Tunnel Monitoring
  • Monitor system
  • Building Monitoring

FDT (Field Device Tool)

FDT (Field Device Tool) standardizes the communication and configuration interface between all field devices and host systems. FDT provides a common environment for accessing the devices’ most sophisticated features. Therefore, by using ICPDAS HART converters, I-7567, I-7570 or I-7547, supporting FDT, users can easily and quickly construct HART online control and configuration system.

LED Indicators
Status PWR / TxD / RxD
COM Ports
Ports RS-232(Tx / Rx / GND) / RS-422 / RS-485
9-pin screwed terminal block
Baud Rate 1200 bps (For FW_v1.1)
1200 ~ 115200bps (For FW_v1.1 / HW_v1.2)
Data Format O(odd parity), 8(data bit), 1(stop bit) (For FW_v1.1)
N/O/E(parity), 8(data bit), 1/2(stop bit) (For FW_v1.1 / HW_v1.2)
HART
Ports 1
Protocol 2-pin screwed terminal block
Power
Reverse Polarity Protection Power reverse polarity protection, Over-voltage brown-out protection
Input Range Unregulated +10 ~ +30 VDC
Consumption 1 W
Mechanical
Dimensions (mm) 121 x 72 x 35 (H x W x D)
Installation DIN-Rail or Wall Mounting
Environment
Operating Temperature -25 ~ +75 °C (-13 to 167 ℉)
Storage Temperature -30 ~ +85 °C (-22 to 185 ℉)
Humidity 5% ~ 95%, Non-condensing
I-7570     CR  Serial To HART Converter (Gray Cover) (RoHS)
TOP HOME