Trang chủ » Industrial Communication » Bộ chuyển đổi Modbus TCP/IP sang HART ICP DAS HRT-711 CR

Bộ chuyển đổi Modbus TCP/IP sang HART ICP DAS HRT-711 CR

Modbus TCP/UDP to HART Gateway

Chia sẻ:
Model: HRT-711 CR
Views: 763

Bộ chuyển đổi Modbus TCP/IP sang HART ICP DAS HRT-711 CR

The HRT-711 Gateway is specially designed for the master device of HART protocol. It allows the Modbus master to access the HART devices. These HART devices may be a transmitter, an actuator and so forth. In addition, we also provide the utility software for users to configure the HRT-711. By using this module, users can integrate their HART devices into Modbus network easily.

  • Industrial Automation
  • Factory Automation
  • Process Automation
  • Etc…
COM Ports
Ports RS-232(3 wires)
Ethernet
Ports 10/100Base-TX Ethernet Controller (Auto-negotiating, Auto_MDIX)
HART
Ports 1
Device 2-wired or 4-wired HART devices
Topology Point to Point or Multi-Drop
Data Only Digital Data
Frame Type Short and Long Frame
Burst Mode Supported
Max. HART Device 15
Loop Resistor 250 Ω resistor by Jumper
Isolation UL1577 Spec.
Protocol 2-pin screwed terminal block
Power
Reverse Polarity Protection Power reverse polarity protection, Over-voltage brown-out protection
Input Range Unregulated +10 ~ +30 VDC
Consumption 1 W
Mechanical
Dimensions (mm) 72 x 35 x 121 (W x L x H) Detail
Installation DIN-Rail or Wall Mounting
Environment
Operating Temperature -25 ~ +75 °C
Storage Temperature -30 ~ +80 °C
Humidity 10% ~ 90% RH, Non-condensing
HRT-711     CR  Modbus TCP/UDP to HART Gateway (RoHS)
TOP HOME