Trang chủ » Truyền thông công nghiệp » Fieldbus Communication » CANopen » Module CANopen 8 kênh PWM + 8 kênh đếm tốc độ ICP DAS CAN-2088C CR

Module CANopen 8 kênh PWM + 8 kênh đếm tốc độ ICP DAS CAN-2088C CR

CANopen Slave Module of 8-ch PWM Output and 8-ch High Speed Counter Input

Tính năng

Module CANopen 8 kênh PWM + 8 kênh đếm tốc độ ICP DAS CAN-2088C CR

  • Hardware-controlled PWM output
  • PWM output frequency: 0.2 Hz ~ 500 kHz with 0.1%~99.9% duty cycle
  • PWM Output Modes: software trigger / hardware trigger
  • Trigger each PWM output individually or all PWM outputs synchronously
  • Support Burst output mode and Continue output mode
  • Provide 32-bit 500 kHz high-speed counter for each DI channel
  • Pass the validation of CANopen conformance test
  • Provide EDS file for CANopen master interface
Chia sẻ:
Model: CAN-2088C CR
Views: 616

Module CANopen 8 kênh PWM + 8 kênh đếm tốc độ ICP DAS CAN-2088C CR

PWM (Pulse width modulation) is a powerful technique for controlling analog circuits. It uses digital outputs to generate a waveform with variant duty cycle and frequency to control analog circuits. CAN-2088C is a PWM slave module of CANopen protocol. It has 8 PWM output channels and 8 high speed counter channels. It can be used to develop powerful and cost effective analog control system, please refer to the following web site.

CPU Module
Watchdog Timer Hardware watchdog
LED Indicators
Status 3 LEDs to PWR, RUN and ERR
Digital Input
Channels 8
Type Wet Contact
Sink/Source (NPN/PNP) Sink
ON Voltage Level +5.5 ~ +30 VDC
OFF Voltage Level <3.5 VDC
Input Impedance 2.2 kΩ, 0.5 W
PWM
Channels 8
Sink/Source (NPN/PNP) Source
Load Current 1 mA
Frequency 0.2 Hz ~ 500 kHz (non-continuous)
Duty Cycle 0.1 ~ 99.9 %
Mode Burst mode, Continuous mode
Trigger Start Hardware (Start and Stop) or Software (Start and Stop)
CANopen
Baud Rate 10 k ~ 1 M
Isolation 3000 VDC for DC-to-DC, 2500 Vrms for photo-couple
Terminal Resistor Built-in 120Ω
Protocol CiA 301 v4.02, CiA 401 v2.1
Node ID 1 ~ 99
No. of PDOs 10 RxPDO , 10 TxPDO
PDO Mode Event Triggered, Remotely requested, Cyclic and acyclic SYNC
Error Control Node Guarding protocol / Heartbeat Producer
NMT Slave
EMCY Message Yes
Power
Consumption 3.5 W
Mechanical
Dimensions (mm) 33 x 99 x 78 ( W x L x H )
Installation DIN-Rail
Environment
Operating Temperature -25 ~ +75 °C
Storage Temperature -30 ~ +80 °C
Humidity 10 ~ 90% RH, Non-condensing

 

CAN-2088C     CR CANopen Slave Module of 8-ch PWM Output and 8-ch High Speed Counter Input (RoHS)
Datasheet Quick Guide
TOP HOME